Quantcast
Channel: EngineerZone : Unanswered Discussions - Power By Linear
Browsing all 2027 articles
Browse latest View live

Image may be NSFW.
Clik here to view.

split the voltage source

sir,how to split the 100 Vdc into a dual supply of 50 V output. which IC can support this.

View Article


split the input voltage source

sir,i have a DC-DC circuit of 60 Vdc to 100 Vdc variable output. So how to get with this 60 Vdc  to 100 Vdc variable input to +- 30 V to +- 50 V variable output.

View Article


Image may be NSFW.
Clik here to view.

Exposed pad of ADP2303

Hello, Is the exposed pad of ADP2303 internally connected to GND pin?  Or floating ?Which should the exposed pad externally connected to in 'inverting' configuration, system ground ? or GND pin level?...

View Article

Hello, I have a question about product ADP5090. If the solar is not available...

I want to use the ADP5090 for a portable solar charger. I would like to know if the solar is not available or doesn't meet the charging requirement can battery be used to supply to the load? The load...

View Article

Image may be NSFW.
Clik here to view.

ADM1278 EVB Board Qurstion

Dear All: I find out UG-601 "EVAL-ADM1278EBZ Evaluation Board User Guide" document verson:0 & A Page9 about ADM1278 ISET.PSET.ISTART. whyexternalresistance parameterdifferent? It’s the same SPEC....

View Article


looking for some photo diode model

Hi there,I want to simulate a circuit with a photo diode.Does ADISIM have some photo diode models in the darult condition? BestTrarzan 

View Article

ADM1278 0XD4 SIMULTANEOUS bit

Hello  my customer request the ADM1278 0xd4 that update as below the table.after checking, I confuse the "SIMULTANEOUS" function! what is the SIMULTANEOUS functionDoes any impact for this updated ??...

View Article

Thermal Information of ADM3260 SSOP & ADE7953LFCSP

Hi there,   Please kindly advise what the listed thermal specification of ADM3260 SSOP & ADE7953 LFCSP are :1. Temperature of junction ? Tj2. Temperature of case ? Tc3. Junction-case thermal...

View Article


Image may be NSFW.
Clik here to view.

Thermal Info of ADM3260 SSOP & ADE7953 LFCSP

Hi there,   Please kindly advise what the listed thermal specification of ADM3260 SSOP & ADE7953 LFCSP are :1. Temperature of junction ? Tj2. Temperature of case ? Tc3. Junction-case thermal...

View Article


ADP5063 and battery charge level

The ADP5063 "hides" the battery voltage (VBAT_SNS) from the system when charging is happening, presenting a constant 3.4 V to the system.  In our application, we would like to display a rough...

View Article

ADM1066 input/output pins are capable of doing multi-tasks

we would like to know that if ADM1066 input/output pins are capable of doing multi-tasks (sequence, monitoring, and margin) or it can only do single task.Or any suggestion for this applcaiton

View Article

Simulate with an AMP03, Importing Models

I have found that the library comes with the AMP01,02, and 04, but not the AMP03. Naturally it is the one I need. I am just now learning this particular suite and I am having trouble adding the desired...

View Article

ADUM5000 radiation emission

Hi ADI team. My customer use ADUM5000W which has 180MHz ocilator internal. Now, this product put out 360MHz (double wave of 180MHz)  of radiation emission with a number 10MHz of width.and this...

View Article


Image may be NSFW.
Clik here to view.

ADP2164 Forced continous switching

I would like to free-run the ADP2164 at ~650Khz but do not want it to go into pulse skip or burst mode with no load.I can calculate the RT value but the question is with the SYNC pin.Can I tie the Sync...

View Article

Image may be NSFW.
Clik here to view.

Can I connect +12V power supply to ADP5071 EVB and get +/-5V output?

Hi; We have a application which need convert +12V input to +/-5V outputs with +/-1A loads. I saw the ADP5071 is just suitable for this. Now I want to buy a EVB to try, but I checked the datasheet of...

View Article


Image may be NSFW.
Clik here to view.

REACH compliance status for 'AD584TH'

Greetings,Please do let us know the REACH compliance status for 'AD584TH'Regards,Siby

View Article

Image may be NSFW.
Clik here to view.

We are using AD5262 Digital Potentiometer to generate -1.5V using LT3015 LDO....

View Article


Hello, I have a question about product ADP5090. If the solar is not available...

I want to use the ADP5090 for a portable solar charger. I would like to know if the solar is not available or doesn't meet the charging requirement can battery be used to supply to the load? The load...

View Article

ADM1278 EVB Board Qurstion

Dear All: I find out UG-601 "EVAL-ADM1278EBZ Evaluation Board User Guide" document verson:0 & A Page9 about ADM1278 ISET.PSET.ISTART. whyexternalresistance parameterdifferent? It’s the same SPEC....

View Article

ADM1278 0XD4 SIMULTANEOUS bit

Hello  my customer request the ADM1278 0xd4 that update as below the table.after checking, I confuse the "SIMULTANEOUS" function! what is the SIMULTANEOUS functionDoes any impact for this updated ??...

View Article
Browsing all 2027 articles
Browse latest View live


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>