Hi
I am trying to make a DCDC converter using the ADP2301. The design is more or less taken from the design tool ADP230x_BuckDesigner_Release.xlsm.
Down below is a picture of my circuit:
I was hoping to get 5V as output, but instead i am seeing 2-2.5V with a lot of ripple. (see picture below)
Here is some more scope pictures for you to understand what is going on.
At BST pin:
Enable pin:
Feedback pin:
And here is the PCB layout. Underneath is a solid GND plane.
_______________________________________________________________
Can anybody help me out here? I am a bit confused about the feedback pin. From the datasheet the regulation voltage is 0.8V which it is designed to be at 5V. Why am i seeing almost 2V when my output is 2.5V?
I have no load at the output, does that have an impact?
Best,
Mathias